Toro ProPass 200 Operator's Manual page 2

This product complies with all relevant European directives,
for details please see the separate product specific Declaration
of Conformity (DOC) sheet.
Electromagnetic Compatibility
Domestic: This device complies with FCC rules Part 15.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference and (2) this device
must accept any interference that may be received, including
interference that may cause undesirable operation.
This equipment generates and uses radio frequency energy and
if not installed and used properly, that is, in strict accordance
with the manufacturer's instructions, may cause interference to
radio and television reception. It has been type tested and found
to comply with the limits for a FCC Class B computing device
in accordance with the specifications in Subpart J of Part 15 of
FCC Rules, which are designed to provide reasonable protection
against such interference in a residential installation. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:Reorient the receiving antenna, relocate the remote
control receiver with respect to the radio/TV antenna or plug
the controller into a different outlet so that the controller and
radio/TV are on different branch circuits.If necessary, the user
should consult the dealer or an experienced radio/television
technician for additional suggestions.The user may find the
following booklet prepared by the Federal Communications
Commission helpful: "How to Identify and Resolve Radio-TV
Interference Problems". This booklet is available from the U.S.
Government Printing Office, Washington, DC 20402. Stock No.
004-000-00345-4.
FCC ID: OA3MRF24J40MC-Base, OA3MRF24J40MA-Hand
Held
IC: 7693A-24J40MC-Base, 7693A-24J40MA-Hand Held
Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device.
Introduction
This Top Dresser is intended to be used by professional,
hired operators in commercial applications. It is primarily
designed for metering and dispersing materials, under a
range of moisture conditions, without clogging or drastically
affecting the dispersion.
Read this information carefully to learn how to operate and
maintain your product properly and to avoid injury and
product damage. You are responsible for operating the
product properly and safely.
You may contact Toro directly at www.Toro.com for product
and accessory information, help finding a dealer, or to register
your product.
Whenever you need service, genuine Toro parts, or additional
information, contact an Authorized Service Dealer or Toro
Customer Service and have the model and serial numbers of
your product ready. Figure 1
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
identifies the location of the
model and serial numbers on the product. Write the numbers
in the space provided.
1. Model and serial number location
Model No.
Serial No.
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
1. Safety alert symbol
This manual uses 2 other words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
2
Figure 1
(Figure
Figure 2
Contact us at www.Toro.com.
Printed in the USA.
All Rights Reserved
2),