Toro ProPass 200 Operator's Manual page 27

Figure 46
1. Rubber seal
2. Steel gasket
4. Remove the discharged batteries and properly dispose
in accordance with local regulations.
5. Plug each fresh battery into a terminal cradle observing
proper polarity. (If the batteries are improperly
installed, the unit will not be damaged, but it will fail
to operate.) The cradle is embossed with polarity
markings for each terminal
6. If you accidentally removed the rubber seal and the
steel gasket, replace them carefully into the channel in
the handheld remote
7. Replace the cover and secure it with the 6 screws
removed previously
to 1.7 N-m (13 to 15 in-lb).
8. Install the handheld remote into the magnetic remote
bracket, slide the halves together to secure the remote,
and tighten the bolt in the magnet
Caring for the Handheld Remote
Though the handheld remote is rugged, care should be taken
not to drop the unit onto hard surfaces. To clean it, use a
soft cloth moistened with water or a mild cleaning solution
to wipe it paying particular attention to avoid scratching the
LCD screen.
3. Handheld remote
4. 4 AA batteries
(Figure 46).
(Figure 46).
(Figure 46) and torque them to 1.5
(Figure 45).
Associating the Handheld Remote with
the Base
The factory initially associates the remote to the base allowing
them to communicate; however, there may be instances in the
field when you must reassociate a remote and a base unit,
as follows:
1. Press the E-Stop button to remove power from the
base unit and make sure the handheld is off.
2. Stand near the base unit in clear line of sight.
3. Simultaneously press and continue to hold the
O /O and the A
N FF
The handheld remote goes through its initialization
screens and settles on ASSOC PENDING.
4. Continue to hold both buttons and then quickly
release them when ASSOC ACTIVE is displayed
(approximately 4 seconds).
The display will show PRESS STORE.
5. Press and hold the S
The remote displays POW UP BASE.
6. While continuing to hold the S
on the E-S button to power up the base unit.
TOP
The handheld remote will associate (link) with the base
unit. Upon success, the display will show ASSOC
PASS.
7. Release the S
TORE
Important: If the display shows ASSOC EXIT , the
association failed.
Note: The Handheld Remote and Base Unit link can be
viewed by holding down the A
buttons at the same time.
The display will cycle and indicate the selected channel and
the ID of the Base Unit.
27
S buttons.
LL TOP
+
button.
TORE
button, pull out
TORE
button.
S and O
LL TOP PTION
+
S
TOP