Installation Of Input/Output Powered Extension Unit/Block And Special Function Block - Mitsubishi Electric MELSEC-F FX3G Series User Manual

FX Series Programmable Controllers
3G
User's Manual - Hardware Edition
8.4.3

Installation of input/output powered extension unit/block and special function block

1
Push out the DIN rail mounting hook (A in the right fig-
ure) of the input/output extension block.
• For input/output powered extension units, 8-point type input/output
extension blocks (except for the FX
extension units/blocks, this operation is unnecessary.
2
Fit the upper edge of the DIN rail mounting groove (B
in the right figure) onto the DIN rail.
3
Push the product against the DIN rail.
• Keep a gap of 1 to 2 mm (0.04" to 0.08") between the products.
4
Connect the extension cable.
-8EYR-S-ES/UL) and special
2N
→ For the procedures on connecting the extension cable, refer to Subsection 8.6.5.
8.4 Procedures for Installing on and Detaching from DIN Rail
8 Installation In Enclosure
Rear panel Rear panel
1
A
B
3
109
1
2
3
4
5
6
7
8
9
10