Installation And Removal; Installation (When The Expansion Board/Connector Conversion Adapter Is Not Used Together) - Mitsubishi Electric MELSEC-F FX3G Series User Manual

FX Series Programmable Controllers
3G
User's Manual - Hardware Edition
19.2

Installation and Removal

Be sure that the power is OFF when installing the display module.
19.2.1 Installation
(when the expansion board/connector conversion adapter is not used together)
The FX -40MT/ES is used as the main unit in this example.
3G
1
Remove the top cover.
Remove the top cover (A in the figure on the right) as shown
in the right figure.
Caution:
Display module cannot attach in the top cover (S) side of a 40/60-
point types main unit.
2
Install/remove the display module.
Attach the display module to the main unit as shown in the
right figure (arrow 2).
Remove the display module while pressing and holding the
display module fixing hook (B in the figure on the right) as
shown in the right figure (arrow 2').
19 Display Module (FX3G-5DM)
19.2 Installation and Removal
Top cover (S)
B
2
11
12
A
13
1
14
15
2'
16
17
18
19
20
313