Adjustment Procedure; Spindle Amplifier Initial Setup; Rotary Switch Setting - Mitsubishi Electric MDS-B-SPJ2 Series Specification Manual

8. Adjustment Procedure

Never drastically adjust or change the parameters. Extreme adjustments and changes of the
parameters will cause the operation to become unstable.

8.1 Spindle amplifier initial setup

8.1.1 Rotary switch setting

The axis No. must be set with the rotary switch before turning the power ON. The rotary switch setting
is validated when the power is turned ON.
When an unused axis is selected, "Ab" will remain displayed on the LED, and that axis will not be
controlled after the power is turned ON.
The system emergency stop cannot be canceled once the power of an unused axis is turned OFF.

8. Adjustment Procedure

CAUTION
Display area
This displays the operation status and alarms.
Setting area
Rotary switch for setting the axis No.
CAUTION
8 − 1

Rotary switch setting

Setting axis No.
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
1st axis
2nd axis
3rd axis
4th axis
5th axis
6th axis
7th axis
Not used
Unused axis