Mitsubishi Electric MDS-B-SPJ2 Series Specification Manual page 8

② Connect the SJ-P and SJ-PF Series spindle motor power lead to the spindle amplifier using a
fixed terminal block. Do not connect the wires directly.
(5) Peripheral devices and options
① Use a no-fuse breaker and magnetic contactor that comply with the EN/IEC Standards
described in section 6-2-1.
② The wires sizes must follow the conditions below. When using other conditions, follow Table 5
of EN60204 and the Appendix C.
• Ambient temperature: 40°C
• Sheath: PVC (polyvinyl chloride)
• Install on wall or open table tray
③ When using the EMC filter, the radio noise filter (FR-BIF) is not required.
(6) Spindle motor
Contact Mitsubishi for the outline dimensions, connector signal array and detector cable.
(7) Others
Refer to the EMC INSTALLATION GUIDELINES (BNP-B8582-45) for other EMC Directive
measures related to the spindle amplifier.