Siemens SINUMERIK 840D sl Function Manual page 662

Detailed description
2.7 Program operation mode
The effect of commands/signals
The program status can be controlled by activating different commands or interface signals.
The following table shows the resulting program status when these signals are set
(assumption: status before the signal is set -> Program status running).
Table 2-3 Effect on program status
Commands
IS "Reset"
IS "NC Stop"
IS "NC stop at block limit"
IS "NC stop axes and spindles"
IS "Read-in disable"
IS "Feed stop, channelsp."
IS "Feed stop, axissp."
Feed override = 0%
IS "Spindle stop"
M02/M30 in a block
M00/M01 in a block
IS "Single block"
IS "Delete distancetogo"
Auxiliary functions output to PLC but
not yet acknowledged
Wait instruction in program
104
Program execution statuses
Aborted Interrupted
X
X
Basic logic functions: Mode group, channel, program operation, reset response (K1)
Stopped Wait
X
X
X
X
X
X
X
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
Running
X
X
X
X
X
X