Mitsubishi Electric MELSEC iQ-R Series User Manual page 332

Function extension bit monitor [Q compatible mode]
In the Q compatible mode, the following contents set in 'Sampling cycle and function extension setting' (in the Q compatible
mode) (Un\G1024) are stored:
• Automatic setting at input range change
• Setting variation rate limiter setting
• Control output cycle unit selection setting
• Moving average processing setting
The following figure and table show how the settings are stored.
b15
0 0 0 0 0
Bit data from b15 to b4 are fixed to 0.
Bit Flag name (Function extension
bit monitor)
b0 Automatic setting at input range
change
b1 Setting variation rate limiter setting
b2 Control output cycle unit selection
setting
b3 Moving average processing setting
(Fixed to 0)
b4 to b15
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory area name
Function extension bit monitor (in the Q compatible mode)
APPX
330
Appendix 3 Buffer Memory Areas
to b4 b3 b2 b1 b0
0 0 0 0 0 0 0
Description
When the input range is changed, the related buffer memory data is automatically changed to
prevent the values in those buffer memory areas from being out of the setting range.
Select whether the setting variation rate limiter to be set in a batch or individually.
Select 0.1s or 1s as a unit for the cycle of turning ON/OFF the transistor output.
In the position-proportional control, 1s cycle (0) is selected.
Select whether the moving average processing setting is used.
(Not used)
• 0: Disable
• 1: Enable
• 0: Set in a batch at temperature rise/temperature drop
• 1: Individually set at temperature rise/temperature drop
• 0: 1s cycle
• 1: 0.1s cycle
• 0: Enable
• 1: Disable
CH1
787
CH2 CH3 CH4