LG Styler S3RERB Service Engineering Manual page 62

11-2. Cycle Characteristics - Styling
Pre
Steam
2(M1050 ~
1800)
Normal
2(M1050 ~
Light
1800)
Heavy
2(M1050 ~
1800)
Moving
hanger
-
operation
Water supply/
drain pump
Steam heater
Component
Main fan
used
Motor
Heat to 95 ℃
after supplying
water to full
level.
Operation
Water supply
error occurs
when the full
water level is
Other not detected
within the
maximum
duration (5
minutes).
Pre
Steam
Heat
9 (M 1050)
- 4 (M 1050)
13 (M 1050)
- -
Comp STEAM HEATER
LEV MAIN FAN MOTOR
Steam heater
Water drain
pump
Main fan motor
Increase internal Operate the steam
temperature to heater for the set
maximize the duration to inject
steam effect. steam.
When Duct In is When low water
maintained for level is detected
10 seconds at during heating, the
a temperature next cycle starts.
above 40 ℃, the - LEV is at 200 when
next cycle starts the cycle starts.
after 10 minutes.
Stay Cooling
2 (P180/M1050) 1 (P180/M1800)
- 1 (P180/M1800)
5 (P200/M1050) 3 (P200/M1800)
Operation: 30 seconds after the cycle started
MAIN FAN MOTOR MAIN FAN
M/H MOTOR MOTOR
M/H MOTOR
- Styling course Operate the main
conducts M/H fan and M/VIH
operation to for the set
maximize the duration.
efficiency of
wrinkle removal.
- Sterilization
course turns
off all devices
and stands by
to maximize the
sterilization effect.
It turns off all Main fan and
devices and moving hanger
stands by when operate for the
the cycle starts. set duration.
※ P : Pulley RPM, M : Motor RPM
※ Data View Pulley RPM = Pulley RPM × 3/5
62
Drying
22
(P180/M1200~
1800)
14
(P180/M1200~
1800)
42
(P200/M1200~
1800)
Water supply/drain pump
Comp
LEV
Main fan motor
M/H motor
Operate the main fan and
comp for the set duration.
Comp operates when the
cycle starts.