Performance - Siemens SIMATIC HMI Unified Comfort MTP700 Operating Instructions Manual

Operating the Control Panel
5.3 System Properties
5.3.6

Performance

Under "Performance" you can activate the monitoring of the internal flash memory.
Flash Memory Monitoring Section
"Show Alarm if life of flash memory is reducing fast": Option to activate flash memory
monitoring. The default setting is "activated".
If the option is activated, the state of the flash memory is checked cyclically. If the cyclical
check results in a high load on the flash memory, the message "Flash memory life time
reducing fast" is displayed regularly.
● "Monitoring Setings": Button for opening the "Performance" settings in the Control Panel.
Press the button, note the cause specified under "Source" and contact the corresponding
administrator or project engineer.
● "OK": Button for acknowledging the alarm.
Last alarm
● "Alarm": Display panel with the last alarm that was displayed about the status of the flash
memory.
● "Source": Display field with information on the cause of the last alarm. Pass this
information on to the administrator or project engineer, who can change the settings in
the corresponding app or the configuration of the HMI device so that the "Flash memory
life time reducing fast" alarm no longer appears.
● "Reset alarm": Button for deactivating the regularly occurring "Flash memory life time
reducing fast" alarm. The button can only be operated by users with the "Control Panel
Administrator" authorization. After pressing the button, the "Flash memory life time
reducing fast" alarm is only displayed again when the next cyclic check results in a high
load on the flash memory.
84
Unified Comfort Panels
Operating Instructions, 03/2020, A5E46641217-AA