Table of Contents
Advertisement
Hardware Preparation and Installation
1
Mounting the Slim Line EIDE Hard Drive
1-12
– J11, J12, J13, J14 for PMC1
– J21, J22, J23, J24 for PMC2
Press all connectors until they are firmly seated.
8. Insert the four screws through the holes on the bottom side of the
CPN5365 and tighten the screws.
9. Reinstall the CPN5365 in its proper slot. Be sure the module is well
seated in the backplane connectors.
10. Reconnect the system to its AC or DC power source and turn the
power on.
You can mount a Slim Line EIDE hard drive in the space for PMC 2. Refer
to
Figure
1-2. No configuration is required. The drive is configured as
master with no jumpers installed.
Slim Line Hard Drive (rear view)
1. Connect the Slim Line EIDE drive cable to the J17 connector on the
CPN5365.
2. Position the drive on the CPN5365.
3. Connect the drive cable to the drive.
4. Secure the drive to the CPN5365 using four screws.
2846 1100
Computer Group Literature Center Web Site
Advertisement
Table of Contents
