To open a lever, press the release and move the lever outward away from
the faceplate.
To close a lever, move the lever inward toward the faceplate until the latch
engages.
Verify Slot Usage
Prevent possible damage to module components by verifying the proper
!
slot usage for your configuration.
Caution
In most cases, connector keying will prevent insertion of a board into an
incompatible slot. However, as an extra precaution, you should be familiar
with the glyphs and colored card rails used to indicate slot purpose.
The following table lists the colors common to MCG chassis.
Card Rail
Glyph
Color
Tan
None
Red
Black
http://www.motorola.com/computer/literature
Table 1-3. Slot Usage Indicators
Usage
MXP: Alarm Management Controller slot
CPX: Hot Swap Controller or Bridge slot
MXP: Fabric Switch Card slot
CPX: System Controller slot
MXP: Payload Card slot
CPX: Non-system Controller or I/O Card slot
Before You Install or Remove a Board
1
1-17