Connecting Devices To Board Connectors; Hardware Configuration - Motorola CompactPCI CPN5365 Installation And Use Manual

Connecting Devices to Board Connectors

The CPN5365 and CPTM-01 rear transition module give you board
connectors for attaching peripheral devices. Before installing the
baseboard or rear transition module, you may want to connect your
peripheral cables to the connectors.
Note
Always remove power from the system before connecting peripherals to
the CPN5365 or CPTM-01. To reduce the risk of personal injury,
disconnect the power cord from the power source. Only qualified,
Warning
experienced electronics personnel should access the interior of a chassis.
The components of the CPN5365 and CPTM-01 are sensitive to static
discharge. While out of the unit, place the modules on a static-dissipative
surface or into a static-shielding bag.
Caution

Hardware Configuration

To produce the necessary hardware configuration and to make sure the
CPN5365 operates properly, you may need to make certain modifications
by settings bits in control registers after installing the module in a system.
Configuration options for the CPN5365 are:
http://www.motorola.com/computer/literature
When the identical function is available through the CPN5365
front panel or the CPTM-01 rear panel, you can use either the
front or the rear, not both.
There are no on-card jumpers or switches
You cannot configure the CPU speed settings
Connecting Devices to Board Connectors
1
1-13