[432] TIE Incoming Assignment
Description
Assigns the TIE incoming method, immediate or wink, to each TIE table according to your
central office service.
Immediate: Incoming TIE calls can be received right after the receiving signal arrives.
Wink: Incoming TIE calls can be received after the wink signal is transmitted to the central
office (after the receiving signal arrives).
Selection
• TIE table number: 1 through 4, ( =all TIE tables)
• Immediate / Wink
Default
All TIE tables – Wink
Programming
1.
Enter 432.
Display: TIE Signal In
2.
Press NEXT.
Display: Table NO?
3.
Enter a TIE table number.
To enter TIE table number 1, you can also press NEXT.
Display example: 1:Wink
4.
Keep pressing SELECT until the desired selection is displayed.
5.
Press STORE.
6.
To programme another TIE table, press NEXT or PREV, or SELECT and the desired TIE
table number.
7.
Repeat steps 4 through 6.
8.
Press END.
Conditions
To assign all TIE tables to one selection, press the key in step 3. In this case, the display
shows the contents programmed for TIE table number 1.
Features Guide References
E&M (TIE) Line Service
E & M Programming
4.4 TIE Line Programming
313