Brother MFC-J615W User Manual page 75

Control panel setup
Gateway
This field displays the current gateway or router address used by the machine. If you are not using DHCP or
BOOTP to obtain the gateway or router address, enter the address you wish to assign. If you do not have a
gateway or router, leave this field blank. Check with your network administrator if you are unsure.
a
Press Menu.
b
Press a or b to choose Network.
Press OK.
c
For DCP-J715W, MFC-J615W and MFC-J630W
(For Wired) Press a or b to choose Wired LAN, and press OK.
(For Wireless) Press a or b to choose WLAN, and press OK.
d
Press a or b to choose TCP/IP.
Press OK.
e
Press a or b to choose Gateway.
Press OK.
f
Enter the Gateway address.
(For MFC models) Press OK.
(For DCP models) Press a, b, d or c to select
Note
For DCP models
To enter the number, press a, b, d or c to select a number displayed on the LCD. Then press OK. Repeat
this step until you have entered all the numbers.
g
Press Stop/Exit.
Node Name
You can register the machine name on the Network. This name is often referred to as a NetBIOS name; it will
be the name that is registered by the WINS server on your network. Brother recommends the name
BRNxxxxxxxxxxxx for a wired network or BRWxxxxxxxxxxxx for a wireless network (where xxxxxxxxxxxx is
your machine's Ethernet address) (up to 15 characters).
a
Press Menu.
b
Press a or b to choose Network.
Press OK.
c
For DCP-J715W, MFC-J615W and MFC-J630W
(For Wired) Press a or b to choose Wired LAN, and press OK.
(For Wireless) Press a or b to choose WLAN, and press OK.
d
Press a or b to choose TCP/IP.
Press OK.
, and press OK.
OK OK
5
5
5
68