Hitachi CE50-10 Instruction Manual page 125

Verifying:20210525101010_sda8_01.gz
The file and the partition doesn't match. Retry?(y / N)y
31MiB 0:00:01 [16.1MiB/s] [====>
Will you verify backup files(y / N)? y
Verifying: 20210525101010_sda8_01.gz
Finished:/mnt/ebackup_data/ecbackup_20210525101010/
20210525101010_sda8_01.gz: xxx,xxx,xxx bytes
Please get 20210525101010_sda8_01.gz. Finished? (y)
(snip)
Directory /media/etc backup start.
Will you verify backup files(y / N)? y
Verifying:20210525101010_etc_01.gz
Finished:20210525101010_sda8_01.gz: xxx,xxx,xxx bytes
Please get 20210525101010_etc_01.gz. Finished? (y)
Successfully completed
Table 5‒26: Description of the screen after backup to the maintenance PC started
Item
(a) to See Table 5‒25: Description of the
(j) screen after backup to external media
started.
(k) Please get
20210525101010_sda8_01.gz.
Finished? (y)
Please get
20210525101010_etc_01.gz.
Finished? (y)
4. Enter q, and then press the Enter key.
The ecbackup command terminates.
For details about running the command, see 5.15.3 Backing up storage data.
<Note>
1. If the command terminates abnormally while data is being backed up to the external media, temporary data in
the process of being backed up might exist in the external media. If the command terminates abnormally,
restart the unit, and then manually delete such data from the external media.
The following describes how to delete the backup data from the external media after restarting the unit.
$ mount /dev/sdb1 /mnt/external
$ ls /mnt/external
ecbackup_YYYYMMDDHHMMSS
The backup work directory is displayed. For YYYYMMDDHHMMSS, a numeric value such as
20210525101010 is indicated as the date and time when the backup work was performed.
$ rm -rf /mnt/external/ecbackup_YYYYMMDDHHMMSS
$ umount /mnt/external
<Diagnosis>
For the exit code, 0 is returned if the status is normal and 1 is returned if an error is detected. Table 5‒27: List of
ecbackup command error messages below shows error messages that are output when an error is detected.
Display
See Table 5‒25: Description of the screen after backup to external
media started.
If a message in Please get file-name. Finished (y)?
format is output, a backup file with file-name is created under the
directory indicated in (b). The example shows that /mnt/
ecbackup_data/
ecbackup_20210525101010/20210525101010_sda8_
01.gz is created.
If this message is output, transfer the /mnt/ecbackup_data/
file-name file to the maintenance PC by using the scp command.
After transferring the file, enter y, and then press the Enter key.
Then, the file indicated by file-name is deleted and saving of the
next backup file starts.
If you press the Enter key without entering anything or enter a
character other than y, the same message appears again and the
system waits for you to enter information again.
ecbackup_YYYYMMDDHHMMSS
5. Configuring Software Environment
] 25% ETA 0:00:02)
Description
...(f)
...(g)
...(e)
...(f)
...(f)
...(h)
...(k)
...(i)
...(f)
...(f)
...(h)
...(k)
...(j)
109