Connection To The Power Supply - Hitachi CE50-10 Instruction Manual

1. Installing the CE50-10
1.3 Connection to the power supply
NOTICE
Do not place the power cable adjacent to a signal cable, as such a cable layout might cause equipment failure or
malfunctions.
Connect the power cable as shown in the following example.
Figure 1‒7: Power supply connection
Connecting to a power supply outlet
Firmly insert the power cable plug into an outlet
Figure 1‒8: Connecting the power cable to an outlet
#
If the only option is to use an outlet that does not have a ground pole, use a grounded to non-grounded conversion
adapter and connect the green ground cable from the adapter to a secure and reliable ground of the building. Verify
that the connections of grounded to non-grounded conversion are correct before use.
Preventing the power cable from being inadvertently disconnected
To prevent the power cable from being inadvertently disconnected, secure it by using a retainer clamp, as shown in the
following figure.
When securing the power cable, make sure that the radius of the cable bundling is at least 40 mm.
8
#
that has a ground pole.