Indicators And Controls On The Unit; Power Switch; Reset Switch (Reset); Test Mode Switch (Auto, Test) - Hitachi CE50-10 Instruction Manual

2. CE50-10 Names and Functions of Parts
2.1 Indicators and controls on the unit
Figure 2‒1: CE50-10 front view
#1
USB ports do not support a locking mechanism. A USB cable might become disconnected if it is inadvertently
knocked, for example. If necessary, fix the USB cable to the retainer clamp (for USB cables) on the front of the
unit by using, for example, a cable tie.
2.1.1 POWER switch
This switch is used to shut down the OS in the case of an error.
Do not use this switch during normal operation. To completely turn off the power, use the main power switch.
If you forcibly turn off the power by pressing the POWER switch for 4 or more seconds, the unit is placed in the
emergency shutdown state. In this state, the unit cannot be started by pressing the POWER switch. In such a case, turn
off the main power switch, and then turn it on again to restore the unit.
2.1.2 Reset switch (RESET)
This switch is used to perform a hardware reset (restarting the unit).
Do not use this switch during normal operation. This switch is also used to collect a memory dump after an error
occurs. To press the RESET switch, insert the eject pin and press the switch. The unit restarts after collecting a
memory dump.
2.1.3 Test mode switch (AUTO, TEST)
Use this switch to set startup mode. Do not change the shipping configuration (AUTO). Set the mode before starting
the unit.
AUTO: Start the unit in normal mode.
TEST: Start the unit in test mode, which is not used in normal operation.
12