Hitachi CE50-10 Instruction Manual page 180

E. Error Messages
Message ID
KXDL001-W
Ethernet adapter(ethX) Link is
down.
ethX: Interface name
KXDL002-W
Ethernet adapter(ethX) collision
retry error.
ethX: Interface name
KXDL003-E Ethernet adapter(ethX) PCIe Bus
Error:
severity=Uncorrected (Fatal).
ethX: Interface name
KXDL005-E
Ethernet adapter(ethX) initial
error.
ethX: Interface name
KXDL006-E
Ethernet adapter(ethX) transmit
timeout error.
ethX: Interface name
KXDL009-E
Ethernet adapter(ethX) Duplicate
IP address.
ethX: Interface name
KXDL010-W
Ethernet adapter(ethX) Duplicate
IP address.
ethX: Interface name
KXDL020-E
Ethernet adapter (ethX) transmit
queue Y timed out.
ethX: Interface name
Y: Queue number
164
Message Cause (meaning)
Link disconnected 2. Check the LAN cable for a fault
3. Confirm that the type of the LAN
4. Confirm that the communication
5. If there are no problems in the
Collision retry error Traffic (communication load) is too
high.
1. Reduce the traffic because
2. If this error frequently occurs
3. If there is no problem in the
Bus error A PCI bus error was detected in the
unit. A unit failure might have
occurred. Replace the unit.
Initialization error An attempt to initialize the LAN
controller failed. Replace the unit
because the LAN controller is faulty.
Transmission A data transmission timeout was
completion timeout detected. Replace the unit because the
LAN controller is faulty.
(transmission TI
monitoring timeout)
Duplicate IP address 1. An invalid IP address might be
(during initialization)
Duplicate IP address
2. A loop configuration network is
(during online)
Transmission queue A transmission queue timeout was
timeout detected. Replace the unit because the
LAN controller is faulty.
Action
(such as disconnection or loose
connection).
cable (straight or cross) is correct.
If it is not correct, replace the
LAN cable.
speed is correct. If it is not, match
the communication speed at the
connection destination.
preceding items, a unit failure
might have occurred. Replace the
unit.
processing delays might be caused
by a large amount of discarded
data due to collisions.
when traffic is low, confirm that
the communication speed is
correct. If it is not, match the
communication speed at the
connection destination.
preceding items, a unit failure
might have occurred. Replace the
unit.
defined on the local host. Correct
the IP address definition file, and
then restart the unit.
not supported. If the unit is
connected to the network that uses
a loop configuration, change the
network configuration.