Setting Up Dual Displays - Hitachi CE50-10 Instruction Manual

5. Configuring Software Environment
Figure 5‒3: Apply button in the Displays screen
6. Click Keep Changes within 20 seconds.
The resolution is changed. If you do not click Keep Changes within 20 seconds, or if you click Revert Settings,
the setting is not applied and the original setting is retained.
Note that any change made in the settings by clicking Keep Changes will be retained after the unit restarts.
Figure 5‒4: Popup screen
(2) Available resolutions
The following lists the display resolutions supported by the CE50-10. Display colors can be set in 24 bits (16,777,216
colors).
Table 5‒2: Display resolution information
Resolution
1,280 x 1,024 (SXGA)
1,920 x 1,080 (FHD)
1,920 x 1,200 (WUXGA)
3,840 x 2,160 (4K UHD)
5.4.2 Setting up dual displays
The CE50-10 has two ports for the DisplayPort interface. A dual display configuration can be created by connecting
two displays to the unit. Dual displays support Join Displays (extended desktop) mode only.
(1) Changing the display mode from dual to single display
1. Click the power icon in the upper right corner of the screen.
The system menu opens.
2. Click the Setting icon.
The Setting screen opens.
3. Select Devices, and then Displays.
The Displays screen appears. This screen contains information about the currently connected displays, as shown
below.
38
Dual displays can be set.
Dual displays can be set.
Dual displays can be set.
Only a single display can be set.
Remarks