Unit Specifications - Hitachi CE50-10 Instruction Manual

A. Unit Specifications
A. Unit Specifications
This appendix describes the CE50-10 unit specifications.
A.1 Unit specifications
Table A‒1: Unit specifications (1/2)
Model
OS
Processor (SoC)
Built-in drive unit
Interface
External dimension (width x depth x height)
#1
The resolution of 3,840 x 2,160 (4K UHD) is supported only for a single monitor (multiple monitors cannot be used).
Table A‒2: Unit specifications (2/2)
RAS function
154
Item
CE50-10
Ubuntu 18.04 LTS (Linux kernel 4.15)
Intel Atom
SSD mSATA SSD (64GB) x1, SATA 6.0 Gbps
Display
USB USB 3.0 x 2
LAN RJ45 x 3ch (1000BASE-T, adopted to Wake on LAN)
Serial Not supported
External contact (EXT) D-Sub25-pin (when an EXT board is mounted)
DI
DO
PSDOWN
210 x 285 x 69mm (excluding the height of the rubber feet)
Item
Specification
(R)
x7-E3950
• DisplayPort x 2
• Video controller: On-boarded
• Colors: 24-bit colors (16,777,216 colors)
• Resolution:
1,280 x 1,024 (SXGA)
1,920 x 1,080 (FHD)
1,920 x 1,200 (WUXGA)
3,840 x 2,160 (4K UHD. It is recommended that the main memory
capacity be 8 GB. (See A.3 Optional parts.)
• Refresh rate: 60Hz
General-purpose input signals
Photocoupler contact x 4
General-purpose output signals
Photo MOS relay contact (form A) x 10
Power supply down signals
Photo MOS relay contact (form B) x 1
Specification
• Hardware state monitoring (such as a temperature error)
• Watchdog timer
• Status Display: RAS indicators (AP, E3, E2, E1), Power lamp
(POWER), Status lamp (STATUS), Drive lamp (DRIVE), Test status
lamp (TEST), LAN board (ACT/LINK lamp (LAN0, LAN1, LAN2),
Speed lamp (LAN0, LAN1, LAN2))
#1