3. Connect the motor cable as follows:
If the power cable is temporarily removed from the grounding shelf, connect the
motor and input power cables except the 360 degree grounding, and then reinstall
the grounding shelf.
•
Ground the shield 360 degrees by tightening the clamp of the power cable
grounding shelf onto the stripped part of the cable (4a).
•
के ब ल की मु ड ़ ी शील् ड को ग् र ाउं ड िं ग टर् म िनल (4b) से कने क ् ट करे ं ।
•
Connect the twisted shield of the cable to the grounding terminal (4b).
•
के ब ल के फे ं ज ़ कं ड क् ट रों को T1/U, T2/V और T3/W टर् म िनलों से कने क ् ट करे ं ।
•
Connect the phase conductors of the cable to the T1/U, T2/V and T3/W terminals.
•
पे ं च ों को नीचे दिए गए टॉर् क पर कसे ं :
•
Tighten the screws to the torque given below:
फ् र े म आकार
Frame size
T1/U. T2/V. T3/W.
T1/U. T2/V. T3/W.
ध् य ान दे ं :
Notes
•
पे ं च अलग-अलग लं ब ाई के होते है ं । उन् ह े ं सही स् थ ानों पर स् थ ापित करे ं ।
• The screws are of different length. Install them at the correct locations.
•
ग् र ाउं ड िं ग शे ल ् फ को पु न र् स ् थ ापित करने के बाद, आप के ब लों के लिए 360 डिग् र ी ग् र ाउं ड िं ग बना सकते है ं ।
• After reinstalling the grounding shelf, you can make the 360 degree grounding for
the cables.
इनपु ट पावर के ब ल
4. चित् र मे ं दिखाए अनु स ार के ब ल के सिरों को तै य ार करे ं ।
Input power cable
टिप् प णी
4. Prepare the ends of the cable as illustrated in the figure.
नं ग ी शील् ड को 360 डिग् र ी पर ग् र ाउं ड किया है ं । शील् ड से बने पिगटे ल को एक PE कं ड क् ट र के रू प मे ं पीले - और-हरे
रं ग से चिन् ह ित करे ं ।
Note: The bare shield will be grounded 360 degrees. Mark the pigtail made from the
shield as a PE conductor with yellow-and-green color.
PE
PE
PE
PE
5. इनपु ट पावर के ब ल को निम् न अनु स ार कने क ् ट करे ं :
R3
N·m
N·m
lbf·ft
2.5...4.5 1.8...3.3
2.5...4.5
4c
4b
4a
HI -त् व रित इं स ् ट ाले श न और स् ट ार् ट -अप गाइड 129
R3
R4
lbf·ft
N·m
N·m
lbf·ft
4.0
3.0
1.8...3.3
4.0
R4
lbf·ft
3.0
EN
HI