Mechanical Installation Of Option Modules - ABB ACS560 Quick Installation And Start-Up Manual

132 Electrical installation
c. Pull the module and remove it.
Note:
Installing option modules
The module can be tightly in position.
Note: In US deliveries, options are already installed at the factory.
3. Align the BIO-01 module with the option module slot in the front of the drive.
Note: If you will install the FPBA
4. Push the BIO-01 option module into position.
adapter module connectors


Mechanical installation of option modules

5. Tighten the locking screw.
See section Overview of power and control connections
Note:
slots for each module. Install the option modules as follows:
If required, you can install fieldbus module on top of the BIO-01 module.
For more information on BIO-01 and other option modules, see chapter Electrical installation
WARNING! Obey the instructions in chapter
in the hardware manual.
you ignore them, injury or death, or damage to the equipment can occur.
Note: Slot 2 in frames R1...R5 is at U
supplies before installing or removing an I/O extension module.
Stop the drive and do the steps in section
b
a
01 module, see section
-
on page 77
3
6
DC
EN - Quick installation and start-up guide 27
FPBA-01 PROFIBUS DP
for suitable connector types.
4
page
Safety instructions
potential. You must disconnect power
Precautions before electrical work
िव य ु त
EN
HI
34 for the available
on page 13. If
on page
थ