Input Power Cable - ABB ACS560 Quick Installation And Start-Up Manual

Motor cable
Motor cable
2. Prepare the ends of the cable as illustrated in the figure. Two different motor cable
2. Prepare the ends of the cable as illustrated in the figure. Two different motor cable
types are shown in the figures (2a.and 2b).
types are shown in the figures (2a.and 2b).
Note: The bare shield will be grounded 360 degrees.
Note: The bare shield will be grounded 360 degrees.
2a
2a
PE
PE
2
b
2
b
PE
PE
3. Connect the motor cable as follows:
3. Connect the motor cable as follows:
• Ground the shield 360 degrees by tightening the clamp of the power cable
grounding shelf onto the stripped part of the cable (3a).
• Ground the shield 360 degrees by tightening the clamp of the power cable grounding
shelf onto the stripped part of the cable (3a).
• Connect the twisted shield of the cable to the grounding terminal (3b).
• Connect the twisted shield of the cable to the grounding terminal (3b).
• Connect the phase conductors of the cable to the terminals of T1/U, T2/V and
• Connect the phase conductors of the cable to the terminals of T1/U, T2/V and T3/W.
T3/W.
3c
3a
3b
• Tighten the screws to the torque given below.
• Tighten the screws to the torque given below.
Frame size
Frame size
T1/U. T2/V. T3/W

Input power cable

T1/U. T2/V. T3/W
4. Prepare the ends of the cable as illustrated in the figure.
Note: The bare shield will be grounded 360 degrees. Mark the pigtail made from
Input power cable
the shield as a PE conductor with yellow-and-green color.
4. Prepare the ends of the cable as illustrated in the figure.
PE
Note:
PE
The bare shield will be grounded 360 degrees. Mark the pigtail made from the shield as a
PE conductor with yellow-and-green color
EN - Quick installation and start-up guide 11
R0...R1 R2
N·m lbf·ft N·m
R0...R1
0.5...0.6 0.4 1.2...1.5 0.9...1.1
N·m
0.5...0.6
Electrical installation 79
lbf·ft
R2
lbf·ft N·m
0.4 1.2...1.5
EN
HI
lbf·ft
0.9...1.1