Motor cable
Motor cable
2. Prepare the ends of the cable as illustrated in the figure. Two different motor cable
2. Prepare the ends of the cable as illustrated in the figure. Two different motor cable
types are shown in the figures (2a.and 2b).
types are shown in the figures (2a.and 2b).
Note: The bare shield will be grounded 360 degrees.
Note: The bare shield will be grounded 360 degrees.
2a
2a
PE
PE
2
b
2
b
PE
PE
3. Connect the motor cable as follows:
3. मोटर के ब ल को निम् न ु स ार कने क ् ट करे ं :
•
Ground the shield 360 degrees by tightening the clamp of the power cable
grounding shelf onto the stripped part of the cable (3a).
•
पावर के ब ल ग् र ाउं ड िं ग शे ल ् फ की क् ल ै ं प को के ब ल के पट् ट ीदार भाग (3a) पर कसकर शील् ड को 360 डिग् र ी
ग् र ाउं ड करे ं ।
•
Connect the twisted shield of the cable to the grounding terminal (3b).
•
के ब ल की मु ड ़ ी शील् ड को ग् र ाउं ड िं ग टर् म िनल (3b) से कने क ् ट करे ं ।
•
Connect the phase conductors of the cable to the terminals of T1/U, T2/V and
•
के ब ल के फे ज ़ कं ड क् ट रों को T1/U, T2/V और T3/W के टर् म िनलों से कने क ् ट करे ं ।
T3/W.
3c
3a
3b
•
Tighten the screws to the torque given below.
•
पे ं च ों को नीचे दिए गए टॉर् क पर कसे ं ।
Frame size
फ् र े म आकार
T1/U. T2/V. T3/W
Input power cable
T1/U. T2/V. T3/W
4. Prepare the ends of the cable as illustrated in the figure.
Note: The bare shield will be grounded 360 degrees. Mark the pigtail made from
इनपु ट पावर के ब ल
the shield as a PE conductor with yellow-and-green color.
4. चित् र मे ं दिखाए अनु स ार के ब ल के सिरों को तै य ार करे ं ।
PE
टिप् प णी
PE
नं ग ी शील् ड को 360 डिग् र ी पर ग् र ाउं ड किया जाएगा। शील् ड से बने पिगटे ल को एक PE कं ड क् ट र के रू प मे ं
पीले - और-हरे रं ग से चिन् ह ित करे ं ।
HI -त् व रित इं स ् ट ाले श न और स् ट ार् ट -अप गाइड 125
R0...R1
R2
N·m
lbf·ft
N·m
R0...R1
0.5...0.6
0.4
1.2...1.5 0.9...1.1
N·m
0.5...0.6
Electrical installation 79
lbf·ft
R2
lbf·ft
N·m
0.4
1.2...1.5
EN
HI
lbf·ft
0.9...1.1