132 Electrical installation
c. Pull the module and remove it.
Installing option modules
Note: The module can be tightly in position.
Note: In US deliveries, options are already installed at the factory.
3. Align the BIO-01 module with the option module slot in the front of the drive.
4. Push the BIO-01 option module into position.
Note: If you will install the FPBA
adapter module connectors
Mechanical installation of option modules
5. Tighten the locking screw.
See section
Overview of power and control connections
Note: If required, you can install fieldbus module on top of the BIO-01 module.
slots for each module. Install the option modules as follows:
For more information on BIO-01 and other option modules, see chapter Electrical
installation in the hardware manual.
WARNING! Obey the instructions in chapter
you ignore them, injury or death, or damage to the equipment can occur.
Note: Slot 2 in frames R1...R5 is at U
supplies before installing or removing an I/O extension module.
EN - Quick installation and start-up guide 27
b
a
01 module, see section
-
on page
3
6
77
for suitable connector types.
4
page
Safety instructions
potential. You must disconnect power
DC
FPBA-01 PROFIBUS DP
34
for the available
on page 13. If
EN
HI