ABB ACS560 Quick Installation And Start-Up Manual page 143

Code Fault / Aux. code
(hex) aux code visible
only on assist-
ant control panel
and drive com-
poser))
5693 Measurement cir-
cuit DFF
5695 Reduced run
5697 Charging feed-
back
5698 Unknown PU fault
50A0 Fan
6181 FPGA version in-
compatible
6306 FBA A mapping
file
6481 Task overload
6487 Stack overflow
64A3 Application load-
ing
8006
8007
8008
Cause
Measurement circuit fault.
Configured power units not
found.
Charging feedback signal
missing.
The power unit logic gener-
ated a fault which is not
known by software.
Cooling fan stuck or discon-
nected.
Firmware and FPGA ver-
sions are incompatible.
Fieldbus adapter A mapping
file read error.
Internal fault.
Note: This fault cannot be
reset.
Internal fault.
Application file incompatible
or corrupted.
Not enough memory for the
application.
The application contains the
wrong system library ver-
sion.
The application is empty.
Diagnostics 143
What to do
Contact ABB.
Configure the power units.
Check feedback signal from charging
system
Check the logic and software compat-
ibility.
Check fan operation and connection.
Replace fan if faulty.
Reboot the control unit with parameter
96.08 Control board boot or by cycling
power. If the problem persists, contact
ABB.
Contact ABB.
Reboot the control unit using paramet-
er 96.08 Control board boot or by
cycling power. If the problem persists,
contact ABB.
Reboot the control unit. If the problem
persists, contact ABB.
Check the auxiliary code. See actions
for each code below.
Reduce the size of the application.
Reduce the number of parameter
mappings.
See the drive-specific log generated
by Automation Builder.
Update the system library or reinstall
Automation Builder.
See the drive-specific log generated
by Automation Builder.
In Automation Builder, give a "Clean"
command and reload the application.
EN
HI