Using The Control Panel; Arrow Buttons; Status Leds; Loc/Rem Button - ABB ACS560 Quick Installation And Start-Up Manual

￭

Using the control panel

1. Clip – Press the clip downward to remove
the panel from the drive.
2. Display – Shows basic home view 1 by
default. See parameter 49.19 Basic panel
home view 1.
3. RJ-45 connector slot – Located on the
back side of the control panel.
4. Back button – Moves back to the previous
menus. In the Home screen, this button
navigates to the Options menu.
5. OK button – Confirms the selected action.
6. Status LEDs –
• Continuous green – Indicates that drive
is functioning normally.
• Blinking green – Indicates an active
warning in the drive.
• Continuous red – Indicates an active
fault in the drive.
7. Arrow buttons – Allows scrolling
up/down/left/right on text pages. In the
Home screen, the left and right arrow but-
tons navigate to different (default or user-
defined) home screens (see parameter
49.19, 49.20 and 49.21).
8. Start button– Starts the drive.
9. Stop button – Stops the drive.
10. Loc/Rem button – Switches between
Local/Remote controls. Local control is
through control panel and Remote control
is through PC or external devices.
EN - Quick installation and start-up guide 33
EN
HI