ABB ACS560 Quick Installation And Start-Up Manual page 149

Code Fault / Aux. code
(hex) aux code visible
only on assist-
ant control panel
and drive com-
poser))
002
003
004
8009 Current limit
80A0 AI supervision
1 - AI1LessMIN
2 - AI1GreaterMAX
80B0 Signal supervi-
sion 1
80B1 Signal supervi-
sion 2
80B2 Signal supervi-
sion 3
80B3 Signal supervi-
sion 4
80B4 Signal supervi-
sion 5
Cause
Overload occurred between
speed point 37.12 ULC
speed table point 2 and
37.13 ULC speed table
point 3.
Overload occurred between
speed point 37.13 ULC
speed table point 3 and
37.14 ULC speed table
point 4.
Overload occurred between
speed point 37.14 ULC
speed table point 4 and
37.15 ULC speed table
point 5.
Motor actual current ex-
ceeded the limit defined in
parameter 30.17 Maximum
current.
An analog signal is outside
the limits specified for the
analog input.
Fault generated by the sig-
nal supervision function 1.
Fault generated by the sig-
nal supervision function 2.
Fault generated by the sig-
nal supervision function 3.
Fault generated by the sig-
nal supervision function 4.
Fault generated by the sig-
nal supervision function 5.
What to do
Check the load.
Check the load.
Check the load.
Reduce the motor load. Check for any
jam or stall in motor. See parameter
30.17 Maximum current.
Check signal level, auxiliary code,
wiring connected to the input and the
minimum/maximum limits of the input
in parameter group 12 Standard AI.
3 - AI2LessMIN
4 - AI2GreaterMAX
Check the source of the fault (paramet-
er 32.07 Supervision 1 signal).
Check the source of the fault (paramet-
er 32.17 Supervision 2 signal).
Check the source of the fault (paramet-
er 32.27 Supervision 3 signal).
Check the source of the fault (paramet-
er 32.37 Supervision 4 signal).
Check the source of the fault (paramet-
er 32.47 Supervision 5 signal).
Diagnostics 149
EN
HI