Output Signal; Product Overview; Layout; Install Optional Modules, If Any - ABB ACS560 Quick Installation And Start-Up Manual

11)

Output signal

Install optional modules, if any

The ACS560-01 drive supports the below option modules:
• CMOD-02 power extension module (for R3...R5 frames)
• BAPO-01 power extension module (for R0...R2 frames)
• BIO-01 I/O extension module (for R0...R2 frames)
• Fieldbus module (in frames R0...R2 frames, fieldbus module can be used with
BIO-01 also)
For information on supported fieldbus modules, see ACS560 product catalog.
For more information on optional modules, see hardware manual.
￭

Hardware description

Product overview

The BIO-01 front option module (Option +L515) is an I/O extension module for R0...R2
frames and can also be used with any of the fieldbus optional module. The BIO-01 I/O
extension module provides:
• three additional digital inputs (DI3, DI4 and DI5)
• one analog input (AI1), and
• one digital output (DO1).
The digital output (DO1) is referred as DIO1 in the firmware. This works only in output
mode. You can also use DI4 and DI5 as frequency inputs and DO1 as a frequency
output.
BIO-01 terminal block is removable and uses spring clamps for assembly.

Layout

1
2
3
EN - Quick installation and start-up guide 25
1. Locking tab
2. Fieldbus option module slot
3. Chassis screw
4. I/O connector
4
EN
HI