Installing Option Modules; Mechanical Installation Of Option Modules - ABB ACS560 Quick Installation And Start-Up Manual

28 EN - Quick installation and start-up guide
EN
HI
c. Pull the module and remove it.
Note: The module can be tightly in position.
3. Align the BIO-01 module with the option module slot in the front of the drive.
4. Push the BIO-01 option module into position.
5. Tighten the locking screw.
Note: If required, you can install fieldbus module on top of the BIO-01 module.
For more information on BIO-01 and other option modules, see chapter Electrical installation
in the hardware manual.
132 Electrical installation

Installing option modules

Note: In US deliveries, options are already installed at the factory.
Note: If you will install the FPBA
adapter module connectors
3


Mechanical installation of option modules

See section Overview of power and control connections
slots for each module. Install the option modules as follows:
WARNING! Obey the instructions in chapter
you ignore them, injury or death, or damage to the equipment can occur.
Note: Slot 2 in frames R1...R5 is at U
supplies before installing or removing an I/O extension module.
Stop the drive and do the steps in section
16 before you start the work.
b
a
01 module, see section
-
on page 77 for suitable connector types.
4
6
potential. You must disconnect power
DC
Precautions before electrical work
FPBA-01 PROFIBUS DP
page 34 for the available
Safety instructions on page 13. If
on page