ABB ACS560 Quick Installation And Start-Up Manual page 38

38 EN - Quick installation and start-up guide
1 Start mode – Automatic, constant time, Fast
2 Stop mode – Coast, Ramp
EN
3 Acceleration time - Time for speed to change from zero to the speed defined by parameter.
HI
4 Deceleration time - Time for speed to change from the speed defined by parameter to zero.
5 Maximum frequency/ Speed - Maximum allowed frequency/speed.
6 Maximum current - Maximum allowed current.
7 Minimum frequency/ Speed - Minimum allowed frequency/speed.
→
Selected start mode is Automatic.
1 1) Automatic - Default start mode. Guarantees optimal motor start in most cases. It includes the
flying start function (starting into a rotating motor) and the automatic restart function. The drive
motor control program identifies the flux as well as the mechanical state of the motor and starts the
motor instantly under all conditions.
2 2) Constant - Enables constant pre-magnetizing time (the motor start is synchronized with the re-
lease of a mechanical brake).
3 3) Fast - The pre-magnetizing time is determined automatically, being typically 200 ms to 2 s de-
pending on motor size. This mode does not have a shortcut icon.
→
Selected stop mode is Coast.
1 Coast - default stop mode. Stops by switching off the output semiconductors of the drive.
2 Ramp - Stops along the active deceleration ramp.
1
3
5
7
1
1
2
4
6
2
2