Start-Up And Use; Before You Start; Using The Control Panel - ABB ACS560 Quick Installation And Start-Up Manual

34 EN - Quick installation and start-up guide
Start up and use
This section describes how to install and start-up the drive using the basic control panel.
Only limited information may be available in this manual. For detailed information of all
Menus and Sub menus, see the ACS-BP-S basic control panel user manual
(3AXD50000032527 [English]).
￭

Before you start

Make sure that the drive is installed as described in section
￭

Using the control panel

EN
HI
1 Clip – Press the clip downward to remove the panel from the drive.
2 Display – Shows basic home view 1 by default. See parameter 49.19 Basic panel home view 1.
3 RJ-45 connector slot – Located on the back side of the control panel.
4 Back button – Moves back to the previous menus. In the Home screen, this button navigates to
the Options menu.
5 OK button – Confirms the selected action.
6 Status LEDs –
• Continuous green – Indicates that drive is functioning normally.
• Blinking green – Indicates an active warning in the drive.
• Continuous red – Indicates an active fault in the drive.
7 Arrow buttons – Allows scrolling up/down/left/right on text pages. In the Home screen, the left and
right arrow buttons navigate to different (default or user-defined) home screens (see parameter
49.19, 49.20 and 49.21).
8 Start button– Starts the drive.
9 Stop button – Stops the drive.
1
2
3
4
6
7
9
10
Install the drive (page
5
8
5).