Connection Procedure: Frames R0; Motor Cable - ABB ACS560 Quick Installation And Start-Up Manual

10 EN - Quick installation and start-up guide
￭ Connection procedure: frames R0...R2
If the drive is connected on an IT (ungrounded) system, make sure that the EMC
filter and Varistor (VAR) is disconnected. For more information, see hardware
manual.
1. Remove the front cover as follows:
• Loosen the retaining screw with a screwdriver (1a).
• Lift the cover from the bottom outwards (1b).
EN
HI

Motor cable

2. Prepare the ends of the cable as illustrated in the figure. Two different motor cable types
are shown in the figures (2a.and 2b).
Note: The bare shield will be grounded 360°.
2a
PE
1b
1a