Connection Procedure: Frames R0 - ABB ACS560 Quick Installation And Start-Up Manual

￭
Connection procedure: frames R0...R2
If the drive is connected on an IT (ungrounded) system, make sure that the
EMC filter and Varistor (VAR) is disconnected. For more information, see
hardware manual.
1. Remove the front cover as follows:
• Loosen the retaining screw with a screwdriver (1a).
• Lift the cover from the bottom outwards (1b).
Motor cable
2. Prepare the ends of the cable as illustrated in the figure. Two different motor
cable types are shown in the figures (2a.and 2b).
Note: The bare shield will be grounded 360°.
EN - Quick installation and start-up guide 11
1a
2a
PE
1b
EN
HI