ABB ACS560 Quick Installation And Start-Up Manual page 13

Input power cable
4. Prepare the ends of the cable as illustrated in the figure.
Note: The bare shield will be grounded 360°. Mark the pigtail made from the shield
as a PE conductor with yellow-and-green color
PE
PE
5. Connect the input power cable as follows:
• Connect the twisted shield of the cable to the grounding terminal (5a).
• Connect the phase conductors of the cable to the L1, L2 and L3 terminals.
• Tighten the screws to the torque given below:
Frame size
L1, L2, L3
6. Connect the braking resistor cable as the motor cable. See step 3.
7. Ground the shield 360° (6a).
EN - Quick installation and start-up guide 13
5a
5b
R0...R1
N·m lbf·ft
0.5...0.6 0.4
R2
N·m lbf·ft
1.2...1.5 0.9...1.1
EN
HI