ABB ACS560 Quick Installation And Start-Up Manual page 49

Auto configuration of I/O's and fieldbus module
You can configure the connected optional modules or/and fieldbus modules
automatically.
1. Switch off the drive and connect the required modules. For more information
on optional modules and its installation, see chapter Electrical installation in
the hardware manual.
2. Switch on the drive and set parameter 07.35 Drive configuration bit list values
to 0.
3. Restart the drive.
The drive configures the connected modules, its respective parameters and
the fieldbus settings.
For example, to auto configure the BIO-01 module and/or FPBA fieldbus modules,
set parameter 07.35 Drive configuration bit list values to 0 and restart the drive.
The drive configures the following parameters automatically:
• sets parameter 07.35 Drive configuration bits 5 (FPBA-01) and 8(BIO-01) to
ON,
• enables BIO-01 related parameters, and
EN - Quick installation and start-up guide 49
EN
HI