ABB ACS560 Quick Installation And Start-Up Manual page 33

If cable conduit box is used, perform the following:
Frames Action
R5
1. Slide the cover upwards (1a) and tighten the retaining screws (1b).
2. Reinstall the module cover (2a) and press the cover at bottom. Tighten the two retaining
screws (2b) with a screwdriver.
R6...R8
1. Install the side plates (1a) of the cable box. Tighten the retaining screws (1b) with a screw
driver.
2. Slide the cover (2a) of the cable box on the module from below until the cover snaps into
place.
3. Reinstall the module cover (3a). Tighten the two retaining screws (3b) with a screwdriver.
1a
EN - Quick installation and start-up guide 33
1b
1b
1a
1b
2a
2a
2b
3a
3b
EN
HI