Toro LT-F3000 Operator's Manual page 11

Key Switch
Use the key switch to control the engine and power to
certain electrical components.
1. Key
2. Key switch
3. Shutoff position (stop)
Cutting-Unit-Drive Switch
Use the cutting unit drive to run or shut off the cutting
units (Figure 4).
Note:
Always put the cutting-unit-drive switch in the
O position when driving the machine between job
FF
sites.
Lift-Control Switches
Use the lift-control switches to raise and lower the
cutting units (Figure 4).
Engine-Speed Switch
Use the engine-speed switch to control the speed of
the engine.
The engine-speed switch
change the engine speed.
Momentarily tap the switch to change the engine
speed by 100 rpm increments.
Press and hold the switch forward to change the
engine to H -I .
IGH DLE
Press and hold the switch rearward to change the
engine to L -I .
OW DLE
Figure 5
4. Intake heater/run position
5. Start position
(Figure 4) has 2 modes to
Parking-Brake Switch
WARNING
The parking brake affects the front wheels
only, and may not keep the machine from
rolling down a slope. The machine could
move unintentionally.
Do not park the machine on a slope.
g290335
1. Locking button
•
To engage the parking brake, slide the small
locking button on the top of the switch back and
press the switch forward
Note:
The parking brake icon displays in the
InfoCenter.
•
To disengage the parking brake, press the switch
back.
Service Brake
The hydraulic transmission provides the machine
with service-brake effect. When you release the
forward or reverse travel pedals or reduce engine
speed, the transmission produces service-brake effect
and ground speed slows or stops the machine. To
increase the transmission-braking effect, push the
transmission pedal into the N
the front wheels provide service brake effect.
DANGER
The service braking system does not keep
the machine from rolling when parked. The
machine could move unintentionally.
Engage the parking brake when you park the
machine.
Emergency Brake
If the service brake is damaged or ineffective, shut off
the engine, engage the parking brake remove the key,
and have the machine repaired.
11
Figure 6
2. Parking-brake switch
(Figure 6).
position. Only
EUTRAL
g289697