Controlling the Position of
the Individual Cutting Units
Use the 3 lift-control switches to raise or lower the
cutting units independently.
Lowering the Cutting Unit
1.
Press the cutting-unit-drive switch to the cut
position.
2.
Press the lift-control switch forward and release.
Note:
The cutting unit engages when it is
approximately 150 mm (6 inches) above ground
level. The cutting unit is in 'float' mode, and
follows the ground contours.
Note:
The lift-control switch automatically
returns to the (N
EUTRAL
release it.
Figure 29
1. Lift-control switches
Raising the Cutting Unit
1.
Pull and hold the lift-control switch.
2.
Release the lift-control switches when the cutting
units are at the needed height.
Note:
The lift-control switches automatically return to
the (N
) position when you release it and the
EUTRAL
cutting unit arms hydraulically lock into position.
) position when you
g287651
Cutting Unit Limited-Lift Position
Limiting Cutting Unit Lift When Driving
Forward
Note:
The limited lift function for driving forward is
enabled by default.
•
While driving forward, momentarily pull the
lift-control switch(s).
Note:
The cutting unit(s) shuts off and it raises
approximately 150 mm (6 inches) above ground
level.
•
The limited lift function shuts off when the cutting
unit is lowered and running.
Limiting Cutting Unit Lift When Driving
Backward
Note:
You must enable the limited-lift function in the
InfoCenter to automatically lift the cutting units when
driving backward.
•
When the limited-lift function is enabled, driving
the machine backward causes all cutting units
raise to the limited-lift position.
Note:
The cutting unit(s) raises approximately
150 mm (6 inches) above ground level.
Important:
The cutting units continue to run
while using limited lift and driving the machine
backward.
•
Driving the machine forward again causes the
cutting unit lower to the float position.
Using the Cutting-Unit Turnaround
Feature
Note:
You must enable the turnaround feature for
the center lift-control switch in the settings menu of
the InfoCenter.
•
Momentarily pull the lift-control switch for the
center cutting unit to raise all cutting units to the
limited lift position.
•
Momentarily push down the lift-control switch for
the center cutting unit to lower all cutting units to
the float position.
Adjusting the Cutting Unit
Auto-Limited Lift
Note:
You enable the cutting-unit Auto Limited Lift
feature in the settings menu of the InfoCenter.
•
Manual limited lift uses the 3 lift-control switches,
and is always available regardless of auto-limited
lift setting in the InfoCenter.
28