Engaging The Cutting Unit Drive; Adjusting The Weight Transfer/Traction Assistance - Toro LT-F3000 Operator's Manual

•
When cutting-unit Auto Limited Lift is enabled,
driving the machine in reverse causes the cutting
units to automatically raise to the limited-lift
position.
•
The cutting units return to the floating position
when driving the machine forward.
To raise the cutting units to the limited-lift position,
momentarily pull the lift-control switches.
Note:
The cutting-unit drives disengage immediately,
and the cutting units raise to approximately 150 mm
(6 inches) above ground level.
Auto-limited lift operates with the cutting units lowered
and rotating.
Engaging the Cutting Unit
Drive
The cutting unit drive engages only when you sit in
the operator's seat; refer to
Presence Seat Switch (page
1. O position
N

Engaging the Cutting Unit Drive

Press the top of the cutting unit drive switch to the
O position (Figure 30).
N
Disengaging All Cutting Unit
Drives
Press the cutting unit drive switch to the O
(Figure 30).
Lowering the Cutting Units
The cutting unit drive switch must be set to the O
position (Figure 30). Operate the lift-control switch(s)
Checking the Operator
22).
Figure 30
2. O position
FF
FF
in a downward direction. The cutting units run when
the cutting units are approximately 150 mm (6 inches)
above ground level.
Adjusting the Weight
Transfer/Traction
Assistance
A variable hydraulic weight transfer system provides
improved tire grip with the grass surface—traction
assistance.
Hydraulic pressure from the cutting-unit lift system
provides a lifting force that reduces the weight of the
cutting units on the ground and transfers the weight
downward to the tires. This action is known as weight
transfer.
Note:
Adjust the amount of weight transfer to suit
operating conditions.
1. Open the hood.
g329895
position
N
29