Toro LT-F3000 Operator's Manual page 25

Lowering the Roll Bar
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key.
2. Remove the hairpins from the roll-bar pins in the
pivot brackets of the lower roll-bar frame
20).
Figure 20
1. Roll-bar pin
2. Pivot bracket upper (lower
roll-bar frame)
3. While supporting the weight of the upper roll bar,
remove the roll-bar pins from the pivot brackets
(Figure 20).
4. Carefully lower the upper roll bar until it rests on
the stops of the lower roll-bar frame.
5. Insert the roll-bar pins in the lower holes of the
pivot brackets (Figure
Figure 21
1. Roll-bar pin (lower position)
6. Secure roll-bar pins to the pivot brackets with
the hairpins.
(Figure
g290634
3. Hairpin
4. Upper roll bar
21).
g290636
Raising the Roll Bar
1. Remove the hairpins that secure the roll-bar pins
to the pivot brackets of the lower roll-bar frame.
2. Remove the roll-bar pins to the pivot brackets
(Figure 22).
1. Roll-bar pin
3. Raise the upper roll bar until the holes in the roll
bar align with the pivot brackets
1. Roll-bar pin
2. Pivot bracket upper hole
(lower roll-bar frame)
4. Insert the roll-bar pins through the upper holes
of the pivot brackets and the upper roll bar
(Figure 23).
5. Secure roll-bar pins to the pivot brackets with
the hairpins (Figure
25
Figure 22
(Figure
Figure 23
3. Hairpin
4. Upper roll bar
23).
g290636
23).
g290635