Toro LT-F3000 Operator's Manual page 35

2. Install the hex plug into the motor end plate
(Figure 40).
Figure 40
1. Hex plug
3. Repeat steps 1 through
other side of the machine.
4. Remove the wheel chocks.
5. Disconnect the tow bar.
Note:
The transmission and brakes are ready
for operation.
6. Stow the 2 bolts 12 x 40 mm and 2 washers 12
mm stored in the platform support rails
40).
Figure 41
1. Bolt 12 x 40 mm and
washers 12 mm
7. Lower the platform; refer to
Platform (page 39).
8. Disconnect the tow vehicle.
9. Check the brake operation of the machine.
g292377
2 for the brake at the
(Figure
g292366
2. Platform support rail
Lowering the
WARNING
Operating the machine without the
braking system working properly may
cause you to lose control of the machine,
resulting in serious injury to you and
bystanders.
Before using the machine, ensure that the
braking system operates correctly. Carry
out initial checks driving the machine at
slow speed. Do not operate the machine
with a damaged or disconnected braking
system.
35