Toro LT-F3000 Operator's Manual page 9

1. Height of cut
Note:
This machine complies with the industry standard stability test in the static lateral and longitudinal tests with the maximum
recommended slope indicated on the decal. Review the instructions for operating the machine on slopes in the Operator's Manual as
well as the conditions in which you would operate the machine to determine whether you can operate the machine in the conditions on
that day and at that site. Changes in the terrain can result in a change in slope operation for the machine.
1. Warning—read the Operator's Manual; wear hearing
protection; remove the key before performing maintenance.
2. Thrown object hazard—keep bystanders away.
134-5112
1. Warning—shut off the engine and remove the key before
releasing or operating safety latches.
decal134-5112
134-4280
3. Tipping hazard—lower the cutting units when driving downhill;
drive slowly when turning; do not turn sharply while traveling
fast; do not operate on slopes greater than 20º.
9
134-5122
decal134-5122
decal134-4280