Auto Designation Startup - Toshiba FL654A User Manual

3.6.2 AUTO Designation Startup

Begin
(i) Install the power, expansion, FL654A,
and I/O modules in the base unit. When
the expansion unit is used, connect an
expansion cable.
(ii) Connect the communication cable.
(iii) Turn ON the power.
Start up
Figure 3-4 AUTO designation startup procedure
FL654A switch settings in step (i)
・Node address: Depends on the system.
・Talker block head and listener block head:
Depends on the system.
・RUN/HALT switch: HALT
・Operation setting switch:
Ethernet setting:
Set according to the system.
Generally, auto-negotiation is set.
I/O composition setting:
I/O module input/output based on
the current I/O module configuration
I/O status setting in down mode:
Depends on the system.
Unified Controller nv Series FL-net Remote I/O Station Module FL654A User's Manual
3.6 Startup Procedure
21
3