Initial Setting; Node Status; Gathering Ras Information Using Terminal Software - Toshiba FL654A User Manual

7.6 Gathering RAS information using Terminal software

When FL654A is operated by "LOCK" or "AUTO", RAS information on FL654A can be gathered by
connecting the personal computer that operates the terminal software with the serial cable.
RAS information that can be gathered is as follows.
RAS information

Node status

Version display
I/O layout
In-ring node map
Cyclic node map
Common memory area
data
RAS counter
Event log
FL-net log

7.6.1 Initial Setting

Just as in "Chapter 5 I/O Configuration Information", connect the FL654A and the PC running
the terminal software with a USB cable.
When the [Enter] is input, and the prompt "Command>" is displayed, it is possible to use it.
Please confirm the connection and the communication setting, etc. when the prompt is not
displayed.

7.6.2 Node Status

Input form DISP MODE
Execution result (example)
Command>disp mode
mode
message : enable
cyclic : enable
LNK
ERR
PVERR
GDLINK : ON (100M - Full Duplex)
DPADR
TEST
Table 7-2 RAS information
Node status of FL654A module
Hardware and software version of FL654A module
Display I/O module layout that is mounted on FL654A
List of node to enter network
List of node to which it enters network, and Cyclic data is valid
Display of content of common memory area that specified node
outputs
RAS counter of FL654A module
Event log of FL654A module
FL-net log information on FL654A module
: RUN (I/O-RUN)
: ON
: OFF
: OFF
: OFF
: OFF
Unified Controller nv Series FL-net Remote I/O Station Module FL654A User's Manual
7.6 Gathering RAS information using Terminal software
Content
7
43