Connecting Pc; Starting Terminal Software - Toshiba FL654A User Manual

5.2 Connecting PC

Connect a PC to the FL654A using the cable between the PC's USB port and the FL654A's TOOL
connection port. (For the connection cable, see Chapter 2.)

5.3 Starting Terminal Software

Start the terminal software, select the port, configure it, and configure the ASCII terminal.
The setting is as follows
Table 5-1 Terminal software port and ASCII terminal settings
Item
Transmission rate
Data bit
Parity
Stop bit
Flow control
Line-feed code for talk
Line-feed code for listen
Local echo
As an example, Figure 5-1 shows the setting screen of Windows Hyper Terminal.
Figure 5-1 Specific HyperTerminal Setup Screen
Settings
19200bps
8 bits
None
1 bits
None
CR
CR
ON
Unified Controller nv Series FL-net Remote I/O Station Module FL654A User's Manual
5.2 Connecting PC
Remarks
5
29