Connecting The 5Sl6 Com Miniature Circuit Breaker And 5Sv6 Com Arc Fault Detection Device; Interfaces Of The 7Kn Powercenter 1000; Ethernet Interface - Siemens Sentron 7KN POWERCENTER 1000 Manual

Installation and connection

4.4 Interfaces of the 7KN POWERCENTER 1000

4.3.2 Connecting the 5SL6 COM miniature circuit breaker and 5SV6 COM arc fault
detection device
If the devices are mounted on the DIN rail, the terminals and the leads are tightened using a
screwdriver.
This must be repeated on the input and output side for the line conductor and the neutral
conductor. The permitted conductor cross-sections are displayed below.
4.4 Interfaces of the 7KN POWERCENTER 1000
4.4.1

Ethernet interface

After mounting, the protection of the Ethernet plug must be removed in order to insert an
Ethernet cable (Cat5 F/UTP or better). This connection enables IP communication of the
7KN Powercenter 1000. If the data transceiver is connected to an Ethernet switch or a router,
the data or parameters can be viewed or set in the whole local network via LAN or WLAN.
Only the IP parameters, such as a static IP address, can be changed in the app via Bluetooth.
A VPN connection or another gateway can be used for advanced access beyond the local
network. For further information, see Chapter Application Examples (Page 77).
The Modbus TCP protocol can be used via the Ethernet interface. For further information, see
Chapter Modbus TCP Connection (Page 60).
32
Circuit protection devices with communication and metering function
System Manual, 06/2021, L1V30827018B-01
0.75 ... 16 mm
2
0.75 ... 10 mm
2