Switching On The Receiver And The Fetal Monitor - Philips 50 T Series Instructions For Use Manual

Switching On the Receiver and the Fetal Monitor

Switching On the Receiver and the Fetal Monitor
26
1. Connect the receiver to the monitor using the interface cable.
2. Disconnect all transducers from the monitor, otherwise telemetry
will not function.
3. Switch on the monitor and its recorder.
4. Switch on the receiver.
5. When you switch on:
• The receiver On light (A) comes on.
• The nurse call light (B) and the battery low light (D) are lit for
one second.
• The transmission INOP light (C) lights and stays lit until the
transmitter is switched on.
6. The telemetry indicator lamp on the monitor lights, indicating
telemetry monitoring mode.
7. Check that
TELE
is annotated on the fetal trace.
Chapter 4 - Monitoring