Table of Contents
Advertisement
Under a Fetal Monitor
Series 50 A and 50 IP
44
The Series 50 A/IP monitors fit inside the slots on the receiver.
To fit the Series 50 A/IP to the receiver:
1. Holding the monitor at a slight angle, sit the front feet in the front
slots (1) along the top of the receiver. The small step on each foot
helps it locate firmly in place.
2. Lower the monitor till the back feet "click" into the back slots (2).
Warning
Make sure that all four feet are located firmly in place
To remove the monitor from the receiver:
Holding the monitor in both hands, press the lock-release buttons,
lift out the back feet and then the front feet.
Chapter 8 - Mounting the Receiver
Advertisement
Table of Contents
